Call Us Today! 1.855.558.1001|info@triadrf.com

full-contact-rf

New Triad CubeSat/NanoSat Amplifier Destined for Space

Triad has designed and launched the new TA1109, a small form factor circuit card amplifier designed to be integrated into CubeSat and NanoSat satellite systems. Weighing in at less than a half an ounce, the TA1109 is perfect for applications where small size and weight reduction is critical. Operating at 2000-2500 MHz, the TA1109 offers up to 4W of output power, with a voltage input range of +9 to +14 VDC.

More information on the TA1109 can be found here.

Triad Releases 4th Generation GaN Bi-Directional Amplifiers

Triad RF introduces the 4000 Series of Bi-Directional GaN Amplifiers (BDA). The units operate in the Low and High C Bands, Federal C-1 and C-2 bands and the 5.2 & 5.8 GHz ISM bands. State-of-the-art GaN devices, along with complex matching circuits for the driver and final devices, allow the 4000 series to deliver twice the RF linear power while only consuming half to one third of the DC power of our previous generation C-Band BDAs! Various models in module or circuit card formats provide 64 QAM TX output powers of 2W, 5W, 10W, and 20W while maintaining 4.4% EVM.

The size of the 64QAM 10W unit (5.3 x 3.25 x 0.57 inches) is the same as the previous generation, but comes with several new features including the following:
– Transmit Output Power Detector
– Radio Input Power Detector
– Improved Low-Noise Amplifier (LNA), lower noise figure (NF).
– Auto detection mode provides an output signal that states whether the unit is in TX or RX.
– Improved TX and RX indicator circuitry
– Status pin indicating if the unit has exceeded acceptable temperature levels or gone into a failure mode.
– Improved base plate temperature output circuitry
– International Protection Rating = IP66
Transmit gain is 25 dB, while receive gain is 11 dB. These units still have the fastest switching time between TX and RX, less than 1 µsec! RF connectors are SMA Female and the DC connector is a 21 pin micro-Dsub.

The first 4000-Series model, the TTRM4010 has already passed environmental testing for a large defense manufacturer of high speed video and data links. Production is expected to begin Q1 of 2018.

Additional information on this product line can be found here: […]

By |November 1st, 2017|BDA|0 Comments

Triad Designs and Ships GaN ENG Broadcast Amplifier

The new TA1205 is a GaN amplifier that operates at 3000-3600 MHz and offers an output power of up to 10 Watts. It boasts a small form factor and light weight, while keeping a high power output which makes it ideal for ENG Broadcast applications where distance and mobility is key.

More information on the TA1205 can be found here:

TA1205

Triad RF Systems Ships Dual Channel C-Band Bi-Directional Amplifier for MIMO Radios

Triad has designed a dual channel version of the popular TTRM1008, which is compatible with nearly all types of military and commercial radios. The TTRM1008D operates at 4.4 to 5 GHz and is capable of an output of 25 Wattsper channel for signals types such as BPSK/QPSK, but is also linear enough to provide up to 5 Watts of power with more complex signal types such as 64QAM. This combination of power and linearity makes the TTRM1008D an ideal companion for both tactical MIMO radios and commercial radios alike.

Additional information on this amplifier can be found here: TA1008D Datasheet

To request more information or a quote please contact sales: [email protected]

By |April 12th, 2017|BDA|0 Comments

Triad Designs Solid State Power Amplifier (SSPA) for CubeSat and NanoSat Systems

The TA1181 has been designed for use from 400 to 450 MHz, and is typically used in but not limited to CubeSat and NanoSat GCS (Ground Station) applications. This amplifier module has a maximum out power of 158 Watts and can be used with a multitude of waveforms, from GMSK/BPSK up to highly modulated signals such as 64QAM and 256QAM for higher data rate applications.
This unit features high speed on/off control, over and under voltage protection, and temperature monitoring all packed into a small form factor.

More details can be found here: TA1181 Datasheet

To request more information or a quote please contact sales: [email protected]

Triad RF Ships Military Radio Amplifiers to Leading Defense Contractor

Triad has completed another shipment of TTRM1008 amplifiers for use in military radio systems to one of the country’s largest electronics and defense systems providers.

The TTRM1008 operates in the 4400-5000 MHz band and is compatible with nearly all military and commercial radio systems. It offers 25 Watts of peak power for signals such as QPSK/BPSK but is also linear enough to provide 5 Watts of power with more complex modulation schemes such as 64QAM.

More information on the TTRM1008 can be found here: TTRM1008

By |February 23rd, 2017|BDA, News|0 Comments

Triad RF Systems Designs Bench-Top Lab Unit for Leading Particle Physics Laboratory.

This lab unit is capable of a power output of 30 Watts and operates at a frequency range from 1200 MHz to 1400 MHz. The compact and rugged design of this system is ideal for bench-top testing and many other applications where both simplicity and portability are required.
Triad offers a wide variety of solutions as they are able to integrate any of their current amplifier products in a bench-top system. In addition they offer different styles of lab units ranging from small simple designs to touch screen enabled, feature packed designs.

By |February 16th, 2017|BDA, Bench Top, PA|0 Comments

Leading MIMO Radio Manufacturer Orders with Triad RF Systems

A leading radio manufacturer specializing in world-class MIMO radios has placed another order with Triad RF for the TTRM1078Q. The TTRM1078Q is a Quad-channel Bi-Directional amplifier capable of an output power of 25 Watts per channel and supports any signal type and modulation format used by MIMO radios today. This ensures robust data link distance and high throughput rates which makes it a versatile solution for both military and commercial applications. Triad RF Systems is proud to be a reliable and trusted supplier of amplifier systems for manufacturers at the forefront of today’s modern technologies.

More information about the TTRM1078Q can be found here.

By |January 11th, 2017|BDA, News|0 Comments

Triad RF Ships Amplifier Systems to Leading UAV Manufacturer in Israel

Triad RF Systems has fulfilled an order placed by a leading Israeli UAV manufacturer which specializes in L-band and S-band HD video, telemetry, and command and control data links. This order includes the TTRM1115-D01, a 2.4 – 2.5 GHz, 12 Watt Bi-Directional SSPA and the TTRM1116-D01, a 1.2 – 1.4 GHz, 50 Watt Bi-Directional SSPA.

Using these amplifier systems from Triad RF, a UAV data link distance of over 120 km was demonstrated.

By |December 20th, 2016|BDA, Delivery|0 Comments

Triad RF Provides NASA with High-Power Amplifier for Data Link

Triad RF Systems has shipped the TTRM1054-D01 to NASA to fulfill their power and data rate needs. The TTRM1054-D01 features proprietary auto-switching circuitry which automatically detects Tx bursts of any modulation type and switches the amplifier accordingly.

The datasheet for the TTRM1054 can be found here.

By |October 13th, 2016|BDA|0 Comments